3D Carbon Seatbelt / Pillar Panel Protection Kit (Scuff Guard) - 2020 Levorg (JDM)

3D Carbon Seatbelt / Pillar Panel Protection Kit (Scuff Guard) - 2020 Levorg (JDM)3D Carbon Seatbelt Pillar Panel Protection Kit Soft plastics line the bottom of even the most expensive luxury vehicles. This makes them susceptible to scrapes. Whether your panels are brand new or scuffed up, this interior protection kit (4 pieces) can overlay those panels and give them a cool 3D carbon textured look. NOT ALL MATERIALS ARE CREATED EQUALLY CUSTOMER MESSAGE "Got them just now, thanks for including a(n) extra set! I've had 2 sets of CF

3D Carbon Seatbelt / Pillar Panel Protection Kit

Soft plastics line the bottom of even the most expensive luxury vehicles. This makes them susceptible to scrapes. Whether your panels are brand new or scuffed up, this interior protection kit (4 pieces) can overlay those panels and give them a cool 3D carbon textured look.

NOT ALL MATERIALS ARE CREATED EQUALLY

CUSTOMER MESSAGE - "Got them just now, thanks for including a(n) extra set! I've had 2 sets of CF look ones from another seller and silver stars kept peeling and the carbon look faded really bad."

When purchasing vinyl overlays, keep in mind that not all materials are created equally. I use premium vinyl which has high initial costs, but are the industry standards for high quality materials. Also made in the USA. - Dragon Wrap™ Carbon Fiber Films (3D Carbon) is a 5.6 mil calendered vinyl film featuring a clear repositionable permanent acrylic adhesive on an air-egress liner. This film has excellent dimensional stability, outstanding durability and outdoor performance. - This repositionable permanent adhesive offers minimal initial bond growing to permanent bonds that facilitates application of large graphics. The air egress liner also aids in large graphic application. - Minimum application temperature is 40 degrees Fahrenheit. - Up to 5 year durability outdoors. Rated EXCELLENT for WATER RESISTANCE, HUMIDITY RESISTANCE, and SOLVENT RESISTANCE.

INSTRUCTIONS

You will want to have a hair dryer or heat gun.

Clean the panels and prepare them for install. Make sure they are clean and free of products like Armor All.  Install the larger strip first.  Please look at the photos closely to see how we aligned it.  It will come close to the rubber seal on the door edge but not touch it.  Align the top and press down from top to bottom until you come to areas that appear to want to crease.  Then apply a little heat until you can lay the rest down. The small piece will fill in the uncovered area left by the large piece.  We chose the two piece install for ease of installation.  It will overlap the larger piece in some areas.  Repeat for the other side.