Water-Wash ABS-like Resin V2 10-100kg Deals

Anycubic ABS-Like Resin V2
Main Features

Anycubic ABS-Like Resin V2
Models Display

Anycubic ABS-Like Resin V2
Resin Parameters

Anycubic ABS-Like Resin V2
Resin Color

Anycubic ABS-Like Resin V2
Recommended Printing Parameters

Anycubic ABS-Like Resin V2
Notes

• Shake the liquid resin before use;
• Clean the resin tank and the molding platform to keep the bottom of the resin tank in light transmission.

• Unscrew the cap and add it to the resin tank according to the equipment requirements;
• Select the correct print parameters and settings for printing.

• After printing, please use the matching tools for post-processing, including blades, diagonal pliers, tweezers, containers, and gloves; clean them with water.

• Remove the printed model from the molding platform with a blade.
• Submerge the model in the cleaning solution, rinsed or ultrasonically washed, then take it out and drained; Anycubic Wash and Cure machine s are suggested to ensure a better effect.
• Proper processing, such as removing support, polishing, coloring, etc.

• Do not discharge wastewater directly into the sewer to avoid contaminating groundwater.
• Heat the wastewater, let most of the water evaporate, and then discard the residue after curing by curing machine and sunlight.

Anycubic ABS-Like Resin V2
Precautions

1. The ideal condition for storing uncured resin is a cool, dark place at room  temperature and protect from light to avoid high temperature or sunlight.
2. Suggested operating temperature is 18-35℃, and a low temperature may affect the printing effect, thus, the resin can be properly preheated before use (not more than 60℃).
3. If the resin pigment settles, it can be used after stirring or shaking.
4. In order to ensure the performance of the resin, please takeout the model in time after cleaning to avoid the model soaking in water for a long time.
5. To ensure the mechanical properties of the model, please perform post curing in time after cleaning and drying.
6. To ensure the ideal performance of the curable material it is necessary to control the intensity and time of the light source after curing. Therefore, the following steps are recommended:
   
   • The intensity of mercury lamp or LED light source is 5-10mW/m2, and the duration is no more than 1 hour (self-regulation);
   • The exposure time in the sun (summer) is around 1 hour;
   • Proximity or long-term exposure under strong light sources such as high power high-pressure mercury lamps is prohibited;
   • It is recommended to print in a dark room or be covered with a lid while printing as resin is a photosensitive material.