8 X 6 RMP™ - CONSOLE + DOOR + DASH

8 X 6 RMP™ - CONSOLE + DOOR + DASH8 X 6 RMP CONSOLE + DOOR + DASH For fastening an RMP to a solid surface, purchase our RMP Fastening Kit Self Drilling Screws + Nylon Spacers. Insert the self drilling screws through the preferred perimeter holes of the RMP. Next, insert the self drilling screws through the nylon spacers. Fasten the self drilling screws into the preferred location of the solid surface. If preferred, a pilot hole may be drilled into solid surface in advance. For

8 X 6 RMP™ - CONSOLE + DOOR + DASH

For fastening an RMP™ to a solid surface, purchase our RMP Fastening Kit™ - Self Drilling Screws + Nylon Spacers.

• Insert the self drilling screws through the preferred perimeter holes of the RMP™.

• Next, insert the self drilling screws through the nylon spacers.

• Fasten the self drilling screws into the preferred location of the solid surface. If preferred, a pilot hole may be drilled into solid surface in advance.

For fastening an RMP™ using adhesive backed fasteners to a vehicle panel, utility case lid, safe door or metal, plastic and glass surfaces, purchase our Adhesive Backed - 3M™ Dual Lock™ Fastener Kit.

To adhere 3M™ Dual Lock™ to an RMP™:

• Clean RMP™ surface with an alcohol wipe and let completely dry.
• Apply included 3M™ Primer 94 to the RMP™ surface that the 3M™ Dual Lock™ will be adhered.
• Remove backing from the 3M™ Dual Lock™ strip and press firmly into place on the RMP™.
• Press further with a rolling pin or place heavy weight onto the newly 3M™ Dual Lock™ backed RMP™ to compress and ensure full contact.

To adhere 3M™ Dual Lock™ to a solid surface:

• Clean the solid surface with an alcohol wipe and let completely dry.
• After adhering the 3M™ Dual Lock™ onto the RMP™, line up the corresponding 3M™ Dual Lock™ strip and secure in place.
• Remove backing from the 3M™ Dual Lock™ while still secured to the RMP™.
• Line up the RMP™ on the solid surface you desire to attach to your RMP™ and press firmly in place.
• Remove the 3M™ Dual Lock™ backed RMP™ carefully to avoid lifting the 3M™ Dual Lock™ that is adhered to your solid surface.
• Press further with a rolling pin or place heavy weight onto your newly 3M™ Dual Lock™ lined solid surface to compress and ensure full contact.

PRO TIP

• For stronger adhesion, apply heat from a hair dryer to warm up the surface and the adhesive, enabling the adhesive to liquefy enough to seep into the surface for a better bond.
• For easier handling or application, it is recommended to cut the 3M™ Dual Lock™ into 1" squares or 1" x 2" strips.

Package Contents:

Compatibility:

Specifications: