Pay in installments of $37.38 with
,
and
Shipping Estimate
USA
- USA
- CAN
- USA
- CAN
Ships within 48 hours · Estimated delivery Aug 16 - Aug 21
Promo Codes Available:
For Your Every Summer RSVP, with Code: SUMMER15
Description
Makita XWT17Z 18V LXT 1/2" Li-Ion Brushless Cordless Impact Wrench - Bare ToolFeatures BL Brushless Motor delivers 520 ft. lbs. of Fastening Torque and 740 ft. lbs. of Nut Busting Torque Compact and ergonomic design at only 6 11 16" long 4 speed power selection switch (0 500 0 1,200 0 1,900 0 2,200 RPM and 0 1,000 0 1,700 0 2,400 0 2,700 IPM) for precise fastening control in a wide range of applications 3 forward and 3 reverse Auto Stop modes for increased efficiency Full speed mode function reduces trigger pull to reach full
Features
- BL Brushless Motor delivers 520 ft. lbs. of Fastening Torque and 740 ft. lbs. of Nut-Busting Torque
- Compact and ergonomic design at only 6-11/16" long
- 4-speed power selection switch (0-500 / 0-1,200 / 0-1,900 / 0-2,200 RPM and 0-1,000 / 0-1,700 / 0-2,400 / 0-2,700 IPM) for precise fastening control in a wide range of applications
- 3 forward and 3 reverse Auto-Stop modes for increased efficiency
- Full speed mode function reduces trigger pull to reach full speed
- Efficient BL™ Brushless Motor is electronically controlled to optimize battery energy use for up to 50 percent longer run-time per charge
- The electronically-controlled BL Brushless Motor efficiently uses energy to match torque and RPM to the changing demands of the application
- Extreme Protection Technology (XPT) is engineered to provide improved dust and water resistance for operation in harsh conditions
- Built-in L.E.D. light with an independent on/off switch illuminates the work area
- Weighs only 6.0 lbs. with battery for reduced operator fatigue (battery not included)
- Rubberized soft grip provides increased comfort on the job
- Makita's proprietary hammer and anvil impact mechanism are manufactured using the best raw materials with the highest quality steel and a unique heat hardening process for maximum fastening and driving power
- Equipped with Star Protection Computer Controls to protect against overloading, over-discharging, and over-heating
- Makita technology delivers category-leading charge time so the battery spends more time working and less time sitting on the charger
- Compatible with Makita 18V Lithium-Ion batteries with a Star symbol
- Only use genuine Makita batteries and chargers
What's in The Box
- 18V LXT Brushless 4-Speed Mid-Torque 1/2" Impact Wrench w/ Friction Ring Anvil (XWT17Z)
- Owner's Manual
Warranty
- 3 Year Limited Factory Warranty
- 30 Day Satisfaction Guaranteed
Specifications
| SKU | XWT17Z |
| Brand | Makita |
| Volts | 18V |
| Power | Cordless |
| Square Drive | 1/2 in |
| No Load Speed | 0 - 500 / 0 - 1,200 / 0 - 1,900 / 0 - 2,200 RPM |
| Impacts Per Minute | 0 - 1,000 / 0 - 1,700 / 0 - 2,400 / 0 - 2,700 IPM |
| Fastening Torque | 520 ft.lbs. |
| Nut Busting Torque | 740 ft.lbs. |
| Dimensions (LxWxH) | 6-11/16 x 3-3/16 x 10-7/8 in |
| Weight | 6 lbs |
Shipping Notes
- Free Standard Shipping on $100+ Orders to the USA.
- Except Preorder products are shipped in 48 hours.
- Delivery to the USA:
- Standard Shipping : 3-10 business days
- If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
- We offer a 30-day return/exchange service after receiving.
- Final sale items are not eligible for returns or exchanges.
- To process your return/exchange, please contact us at [email protected]
- Please click here for more details>>> Return & Exchange Policy
4.7 ★★★★★
Based on 20 reviews
Sort
Product Reviews
★★★★★ 5
Perfect hole placement
Size: 11 Holes
Worked exactly as described.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on September 24, 2025
★★★★★ 5
Good jig
Size: 11 Holes
The jig itself is great. The markings make it easy to be consistent; the design is well thought-out; and the build quality is good. I would recommend replacing the drill bit, though. A nice brad point will serve you better.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on December 5, 2025
★★★★★ 5
Great
Size: 11 Holes
Worked better than expected
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on March 10, 2026
★★★★★ 2
In the trash after a single use
Size: 11 Holes
For context, I’m a seasoned woodworker and always evaluate tools with the price in mind. This seemed like a good deal and in fact when it arrived, it looked and felt like reasonable quality for the price. Unhappily, the first bookshelf I drilled was off from side to side by almost 3 mm which would make a really wobbly shelf situation. It took a while to figure out what was happening, but I finally realized the metal bushings that guide the drill bit are so soft that they cored out from contact with the bit even though I was cautious to not put the bit in under power but to get it in the bushing and aligned before drilling. Still, the bushings started angling immediately. So when you then use those angled bushings to set the pin for the next series, it’s off by a little bit. Then the next is off by a little more…. By the time I drilled holes up and down a 6’ high shelf, the bushings were out of square, the holes were 3 mm out of alignment, and the shelf sides were firewood. Back to the drawing board and this goes in the trash, I’m afraid.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 3, 2026
★★★★★ 5
Finally, A Great Trackball for Macs
After reading the other Amazon reviews, I thought I would respond to some of the issues other reviewers raise from a Mac user's perspective. I run a new PowerBook 15" with OS X 10.3.2.
Unlike some other reviewers, I didn't notice any directional/orientation problems--the cursor follows the ball movement very well, even before installing the included Logitech software. Perhaps the necessary drivers are now universally available, or perhaps the Mac version is just better. Also, the "finger layout" has not proven to be an issue for me--I can use any or all of my fingers to control the ball without any cursor-direction problems.
The wireless function has proven flawless on my Mac. The reciever is a couple feet away and actually off the desk (no line of sight) and works fine. It was essentially plug-and-play on the Mac--I didn't even have to push the 'Connect' buttons to establish a signal, it just worked.
The software is necessary, however, to re-assign new functions to the several buttons on this model. As a former PC user, I can't go without a right-click button (one of the reasons I bought an external device for my notebook at all). The Mac software is very easy to use, and one can re-program all of the buttons and the wheel if one so desires. You can set a button to automatically double- or triple-click, or select keyboard shortcuts (e.g., Command and W to close the current window). Very easy, and quite useful--I use buttons to close windows, quit programs, delete files, and still have a handy web-browsing 'Back' button.
The only possible drawback to the Mac software is that one cannot "train" the ball's orientation (from what I can gather from other reviews, this option is not available on PC either). This really only matters if you know you hold trackballs at a different angle than most people do.
Please note that the software I'm reviewing is for Mac OS X only; the program for those running OS 8.6-9.2 is a different piece of software, which is also included in the package.
Those are all the Mac-specific comments I can think of at this point; if you're a Mac-user you're probably used to things "just working," and this device is no exception.
I'll also comment on some of the more universal issues raised by other reviews:
Ergonomically, there is a period of adjustment--anyone moving from a conventional mouse to any trackball or from one trackball to another should expect that. It's never a bad idea to try one out in-store to see how they feel, especially since trackball models vary from one to another much more than mice do.
This is not, as some have termed it, a 'disadvantage'--all new things take some time to get used to. If you've never used a trackball, it's weird for a while; it's also ergonomically superior/healthier in the long term.
Also, I use trackballs for computer drafting/design, and find superior control to mice--finger-control is just more precise than either thumb-controlled trackballs or wrist/arm-controlled mice.
The optical ball-tracking technology requires almost no cleaning, and there are zero moving parts to clean. Just pop the ball out and blow any collected lint out of the socket if necessary--which very rarely is.
For any pointing device that's wireless, optical, and has this many buttons, this price is pretty decent--lower, I think, than my previous trackball that was wired and lacked the wheel.
As for Logitech's reputation/reliability, I have had good experiences. My first trackball had to be replaced during the warranty period, but its replacement has lasted the four years since--I only replaced it now because it wasn't Mac-compatible. Now Mac-users can rejoice with a high-performance trackball that works seamlessly in OS X.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on February 11, 2004