PRIMAL Drag 55 V2 Supreme Engine Package

PRIMAL Drag 55 V2 Supreme Engine PackagePlease note all Big Block engines are built to order, expect circa 7 14 days for shipment. The TAYLOR 55 Supreme is a fairly new engine in the TAYLOR Big Bore line up, its all about an explosion of mid range and top end power. This Complete 55 Dragster engine package comes with everything you need to fit the billetreed engine into your car and get down the track! Hooks right up to the HD dragster clutch belland carrier so you can make use of the full

Please note all Big Block engines are built to order, expect circa 7 - 14 days for shipment.

The TAYLOR 55 Supreme is a fairly new engine in the TAYLOR Big Bore line up, its all about an explosion of mid range and top end power.

This Complete 55 Dragster engine package comes with everything you need to fit the billetreed engine into your car and get down the track! Hooks right up to the HD dragster clutch belland carrier so you can make use of the full range of gearing and 2-speed options available.

Also you have the choice to upgrade to our world record setting V3 62mm Clutch system to get the power down. This will then require the use of blackbone gears.

The WJ146 carb will come preset on rich settings ready for bedding-in the engine while you getused to the massive increase in Horsepower and torque. You will be supplied a free Yamadude linkage set

55 V2 SUPREME Dragster Package Spec list:

• 55cc Billet Reed Engine
• TAYLOR Custom SUPREME Cylinder.
• Custom made lightweight full circle crankshaft.
• TAYLOY Dragster Fitment Side Pipe.
• V2 Oppama Ignition System for less weight, better spark and more reliability
• TAYLOY V Force Reed System with 8 custom high tension carbon-fibre petals.
• Shipped with our WJ146 Carb
• TAYLOR BILLET HD PULL STARTER
• Ram Air Dual layer Air Filter
• UFC Sintered Steel Clutch set
• Custom Primal Dragster LH Engine brace from 3mm stainless steel.
• Custom Billet Rear engine bracket which replaces the stock mount.
• The famous TAYLOR Official Hat
• Yamadude linkage

NB. Fitment into the Dragster is extremely simple, we provide all the required fitment brackets to replace the ones which suit the stock engine. The pipe attaches via supplied bracket to two existing threaded holes in the side rail of the car. The only part that requires modding is the plastic cage, you can either remove it, or as per photos cut off one of the 3 legs so that it still looks consistent and just misses the carb.

Custom Anodising is available in all colours and even Dual Colour Splash anodising! Please just get in touch after placing an order to discuss.