Genuine Siemens Deka 220 lb/hr Low-Z Fuel Injector

Genuine Siemens Deka 220 lb/hr Low-Z Fuel InjectorThese injectors flow 220 lbs hr at 43. 5 PSI ( 3 BAR ) and more at higher PSI! These units are low impedance and require peak and hold injector drivers or additional resistors for saturation drivers. Despite the high flow rate, they are linear and controllable at low pulse widths compared to other extreme flow injectors! These injectors are sometimes referred to as 212lb hr or 225lb hr injectors. These injectors will allow you to run methanol, ethanol

These injectors flow 220 lbs/hr at 43.5 PSI ( 3 BAR ) and more at higher PSI! These units are low-impedance and require peak and hold injector drivers or additional resistors for saturation drivers. Despite the high flow rate, they are linear and controllable at low pulse widths compared to other extreme flow injectors! These injectors are sometimes referred to as 212lb/hr or 225lb/hr injectors.

These injectors will allow you to run methanol, ethanol and other flex fuels with fewer injectors for high horsepower applications. Don't settle for questionable modified high flow injectors when you can have Genuine Siemens quality and performance with these injectors. These injectors are perfectly suited for Extreme horsepower turbo & supercharger applications.

Injector flow rates are based on testing with n-Heptane test solvent (0.6855 g/ml). U.S. EPA emission test gasoline 40CFR86.113 (0.735g/ml) flows in most common injector designs at about a 3 to 4% higher rate than n-Heptane. A ratio of 1.035:1 can be used when converting the flow specifications above.

Specifications:
-Coil Resistance: 2.27 Ohms / Low Impedance / Low-Z (ECM peak & hold driver or modifications required)
-Static Flow Rate @ 43.5PSI ( 300kPa ) w/Gas: 220 lb/hr = 2433 cc/min
-Offset: 0.64ms
-Turn on time: 1.5ms
-Turn off time: 1.3ms
-Connector: Bosch EV1
-Series: DEKA 4 ( DEKA IV )
-Orifice Type: Single Orifice
-Spray Pattern: 10-15 Degree Pencil Cone
-Factory fitted with Viton upper and lower o-rings
-Minitimer connectors (square Bosch EV1 style)

Features:
-Genuine, reliable Siemens Injectors
-Excellent response characteristics
-Robust Design
-Low Impedance
-Fits in most Deka I, Deka IV Long Style, Deka V Long Style, & Deka VII Long Style applications

Equivalent Part Numbers:
-Siemens FI114212
-Siemens 110333