Fanatec Podium DD1 / DD2 Dash BoardFanatec Podium DD1 DD2 Dashboard Introduction Upgrade your sim racing experience and be in total control with our Fanatec Podium Dashboard. Made with real carbon fiber for no flex and ultimate control of your simulated race car. Compatibility PC: Requires 1 USB connection (includes 1 6ft USB cable) Plug and Play: No additional software needed Key Features Premium Construction Material: 6mm Real Carbon Fiber Matte Twill Weave Plate Mounting: Mounts

Fanatec Podium DD1 / DD2 Dashboard

Introduction

Upgrade your sim racing experience and be in total control with our Fanatec Podium Dashboard. Made with real carbon fiber for no flex and ultimate control of your simulated race car.

Compatibility

• PC: Requires 1 USB connection (includes 1 - 6ft USB cable)
• Plug and Play: No additional software needed

Key Features

Premium Construction

• Material: 6mm Real Carbon Fiber Matte Twill Weave Plate
• Mounting: Mounts directly to Fanatec Podium Wheelbases with supplied M6 bolts

Comprehensive Controls

• Left Side:

  • 1 On/Off Latching Toggle with Guard
  • 1 Apex Branded Engine Start Button
  • 3 MOM OFF MOM Toggles with black boot
  • 5 12mm Momentary Push Buttons
    • Multi-switch option adds a 7-way multi-switch to replace the center push button (Up, Down, Left, Right, Push, Encoder Left & Right)

• Right Side:

  • 8 12mm Momentary Push Buttons
  • 4 CTS Encoders
  • 1 Billet Aluminum Brake Bias Knob (can be used for other settings)

Installation Notes

Compatibility Confirmation

Please confirm that this will fit your setup. The dash has enclosures and cables that come out of the rear, which may not fit certain mounts and may need spacers to fit properly. If unsure, please contact us.

EMI Concerns

Some customers have reported EMI from Fanatec wheelbases. If you are experiencing button press issues, you will need to ground the dash to the wheelbase with the provided wire.

Grounding Instructions

1. Step 1: Remove the rear enclosure plate with a 2mm Allen Key.
2. Step 2: Strip about 1 inch off the wire, route it to the wheelbase, and wrap it around the M6 bolt between the rear of the dash and the front of the wheelbase as pictured below.
3. Step 3: Mount the dash as normal with the wire between the carbon plate and the wheelbase.

If you need assistance, please contact support.