Small, fine and safe: the electronics pliers for fine installation work

Tips at a 45°angle: 145 mm long for plenty of freedom of movement even where space is restricted

Electronic equipment, printed circuit boards and precision constructions such as measuring equipment or delicate apparatus are usually built in tight spaces. A compact tool is therefore needed which can also be used to work well even in poorly accessible areas. With a length of 145 mm and their long, slim and flat head, the 35 82 145 electronics pliers from Knipex are the ideal tool for the delicate gripping, holding and bending of sensitive components. The gripping surfaces are smooth ground to protect sensitive surfaces. The 35 mm long tips are at a 45° angle for ideal access also to concealed parts.

Smooth operating and accurate, with box joint design and double spring

The accurate, well-measured transmission of manual force to the component is crucial with gripping pliers for small and sensitive components. The mechanics of the Knipex 35 82 145 are very finely adjusted. The box joint is solid and smooth operating because the inner handle is guided on both sides by the outer handle. This ensures precise running without any tilting effect. The low friction double spring supports the gentle opening of the pliers.

High Knipex quality standards and safety rust protection

The handles of the Knipex 35 82 145 electronics pliers are forged from special tool steel, oil-hardened, carefully deburred, mirror-polished and completed with opening spring and rivet to produce gripping pliers. The rust protection is safe for circuits because there is no chrome-plating, which means that no pieces of chrome can peel off and fall onto printed circuit boards. The mirror polish in conjunction with a fine oil film applied in the factory provides perfectly adequate corrosion protection for the pliers during workshop use. It is sufficient for the oil film to be replaced occasionally.