Skim Coat UV Resin Hard Type for Thin Coats

Skim Coat UV Resin Hard Type for Thin CoatsUses Very Thin Coats & Glazing Great for layering thin coats with a gloved finger (Finger Cot) or thin silicone brush or paint brush. If coating pens, this formula is slightly more viscous, allowing you to coat quicker and more even. Repair & Adhesion Adhere phone grip or badge reel blanks, rhinestones or pearls to your pieces (great to bling up your pens) Sealing, and Protection Finish custom pens or other pieces that require a thin coat while

Uses

Very Thin Coats & Glazing
Great for layering thin coats with a gloved finger (Finger Cot) or thin silicone brush or paint brush. If coating pens, this formula is slightly more viscous, allowing you to coat quicker and more even.

Repair & Adhesion
Adhere phone grip or badge reel blanks, rhinestones or pearls to your pieces (great to bling up your pens)

Sealing, and Protection
Finish custom pens or other pieces that require a thin coat while providing maximum UV protection to prevent yellowing over time

• NOT STICKY!
• Fast Curing - cures in about 90-120 seconds
• Easy to Use
• Non-toxic Once Cured
• Medium Viscosity
• High Gloss Finish
• Extremely High UV Resistance Coating - Anti-yellowing

Lamp Wattage and Cure Time
We recommend using the MagicCure™️ LED Lamp - Please see the lamp information to get more information on curing time! 

How to Coat with UV Resin Skim Coat:

Gloved Finger
Prep piece as directed and make sure it is clean. Using a gloved finger, squeeze a small amount directly onto the piece you would like to skim coat. In the same direction, run your gloved finger along the piece until an even coat is achieved. Add glitter or vinyl if you choose. Allow the resin to self-level and then cure under the lamp for 60-180 seconds. Repeat until you reach desired look.
*Pro Tip: If adhering UV resin to a piece that was coated with epoxy first, sand lightly with 1200+ grit sandpaper and wipe clean with rubbing alcohol and a lint-free cloth

Active Ingredients: Isobornyl Acrylate

Sizes to Choose from:  1KG or Liter (35.2 oz.)
                                        250ml (9 oz.)
                                        100ml (3.5 oz.)
                                        50ml (1.7 oz.)
                                        25ml (1 oz.)

Resin Rockers UV Resin is not formulated for 3D printing. It is designed for crafting, coating, doming, and resin art applications only. Using this resin in a 3D printer may result in improper curing or damage to equipment.

Your safety is our #1 priority so it is important you follow all precautions. This goes with any brand of UV Resin. Resin Rockers UV Resin Skim Coat is a quick cure, medium viscosity coating resin, and adhesive chemical. Everyone reacts differently to everything, so it’s important to wear nitrile gloves, a respirator mask, and appropriate clothing to protect your skin, in addition to working in a well-ventilated area.

• Age recommendation for use is 15+
• Wear nitrile gloves to protect the skin in case of an allergy. We sell finger cots, but please note they are latex.
• Wear a mask if you have respiratory sensitivity. All brands of UV Resin can let off fumes when it first starts to cure. It is the chemical reaction that occurs when the UV light penetrates the resin itself. We always recommend safety precautions with any chemical product.