kennametal tlve p long venturi nozzle

kennametal tlve p long venturi nozzleThe TLVE P Series is a tungsten carbide long venturi nozzle combining a polyurethane jacket with a brass thread connection. The venturi bore accelerates abrasive and distributes it evenly across the blast pattern, delivering up to 40% greater production rates than straight bore nozzles. The polyurethane jacket reduces overall nozzle weight compared to all brass alternatives. Suited for physically demanding contractor and industrial blasting

The TLVE-P Series is a tungsten carbide long venturi nozzle combining a polyurethane jacket with a brass thread connection. The venturi bore accelerates abrasive and distributes it evenly across the blast pattern, delivering up to 40% greater production rates than straight bore nozzles. The polyurethane jacket reduces overall nozzle weight compared to all-brass alternatives.

Suited for physically demanding contractor and industrial blasting applications, these nozzles are designed for use with a 1" internal diameter blast hose. The tungsten carbide liner performs reliably with mineral slag, coal slag, and standard steel abrasives. The reinforced polyurethane upper body provides structural protection against the knocks and drops typical of active blasting job sites, without the additional weight of a full metal jacket.

The brass thread positions the TLVE-P in the middle of the TLVE range — offering a more durable thread connection than the polyurethane-threaded TLVE-AP, while remaining lighter than the all-brass TLVE-Bruiser. For operations where nozzle weight during long blasting shifts is a primary concern, the SN156 Series provides a BP200 SiAlON alternative with comparable service life at approximately half the weight.

Key Features

• Polyurethane jacket with brass thread connection — balance of weight reduction and thread durability
• Long venturi bore: up to 40% greater production rate than straight bore nozzles
• Evenly distributes abrasive across the full blast pattern
• Tungsten carbide liner: reliable service life with mineral slag, coal slag, and steel abrasives
• Reinforced polyurethane upper body for structural protection on demanding job sites
• Suitable for use with steel shot, steel grit, mineral slag, and coal slag
• Thread: 1-1/4" NPSM Note: Most blasting systems worldwide use 50 mm thread nozzles. Verify compatibility or select a matching nozzle holder/adapter for this thread type.

Available Sizes & Lengths
Available in nozzle sizes #3, #4, #5, #6, #7 and #8, with lengths ranging from 111.1 mm to 231.8 mm.