SKU: 65620856992

Happymodel X12 5-IN-1 F4 12A Whoop AIO Flight Controller - Choose Receiver Option

Sale price$71.09 Regular price$78.99
Save 10%

Pay in installments of $19.75 with ShopPay, AfterPay and Klarna

Shipping Estimate
USA
  • USA
  • CAN

Ships within 48 hours · Estimated delivery Sep 19 - Sep 24

Promo Codes Available:

For Your Every Summer RSVP, with Code: SUMMER15

Description

Happymodel X12 5-IN-1 F4 12A Whoop AIO Flight Controller - Choose Receiver OptionThe world first 5 IN 1 AIO flight controller, OPENVTX(up to 400mw), 12A Brushless Blheli_S ESC and Betaflight OSD coming out recently. It comes with onboard SPI ELRS receiver which support ELRS TX module 2. x firmware, and also provide other receiver option like SPI Frsky receiver which support Frsky D8 D16 , REDPINE and SFHSS. This is an amazing flight controller for Brushless whoop. You could get unbelievable RX and VTX range by using this flight

The world first 5-IN-1 AIO flight controller, OPENVTX(up to 400mw), 12A Brushless Blheli_S ESC and Betaflight OSD coming out recently. It comes with onboard SPI ELRS receiver which support ELRS TX module 2.x firmware, and also provide other receiver option like SPI Frsky receiver which support Frsky D8/D16 , REDPINE and SFHSS.
This is an amazing flight controller for Brushless whoop. You could get unbelievable RX and VTX range by using this flight controller.

Check out all our Flight Controllers and the rest of our HappyModel Products!

Specifications:

 

Flight controller

X12 ELRS V2.2 flight controller built-in ELRS 2.4G receiver Target: CRAZYBEEF4SX1280
X12 PNP V1.0 flight controller without onboard receiver Target CRAZYBEEF4DX
MCU:STM32F411CEU6 (100MHZ, 512K FLASH)
Sensor: ICM20689 or BMI270 or ICM42688P(SPI connection)
Mount hole size: 25.5mm*25.5mm
Power supply: 1-2S battery input (DC 2.9V-8.7V)
Built-in 12A(each) Blheli_S 4in1 ESC
Built-in Betaflight OSD(SPI Control)
Built-in 5.8G OpenVTX 0mw~400mw
Built-in ExpressLRS 2.4G
Built-in voltage meter sensor , voltage meter scale 110Built-in current meter sensor , current meter scale 470

VTX antenna: U.FL
Weight: 5.1g
Support 1-2S Lipo/LIHV battery
Size: 30mm*30mm*8mm

Onboard 4in1 ESC Power supply: 1-2S LiPo/LiPo HV
Current: 12A continuous peak 15A (3 seconds)
Support BLHeliSuite programmable
Factory firmware: Z_H_30_REV16_7.HEX
Default protocol: DSHOT300
Support Bluejay firmware
When use Blujay firmware with 48khz, should set startup power to 1100/1200
Onboard SPI ExpressLRS 2.4GHz Receiver Packet Rate option: 50Hz/150Hz/250Hz/500Hz
ExpressLRS Firmware version: V2.2
RF Frequency: 2.4GHz
Antenna : SMD antenna
Telemetry output Power: <12dBm
Receiver protocol:  SPI ExpressLRS
Compatible with ExpressLRS V2.0 TX Module
Couldn’t flash separately ExpressLRS firmware
Onboard 5.8g OPENVTX Firmware version: OPENVTX
Smartaudio v2.1
PIT Mode support
RCE Mode support
Channels:48ch
Transmitting Power: 0/RCE/25mw/100mw/400mw
Power supply: DC 5V
Current (5v): <650ma (400mw)
Antenna connector: U.FL

Package Includes:

  • 1 x Happymodel X12 5-IN-1 F4 12A Whoop AIO Flight Controller - Chosen Receiver Option

 

Shipping Notes
  • Free Standard Shipping on $100+ Orders to the USA.
  • Except Preorder products are shipped in 48 hours.
  • Delivery to the USA:
  1. Standard Shipping : 3-10 business days
  • If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
  • We offer a 30-day return/exchange service after receiving.
  • Final sale items are not eligible for returns or exchanges.
  • To process your return/exchange, please contact us at [email protected]
  • Please click here for more details>>> Return & Exchange Policy
SKU: 65620856992

Discover Niche Categories That Outsell

Top-Converting Item to Boost Your Average Order

4.5 ★★★★★
Based on 17 reviews
Sort
Highest Rating
Newest First
Oldest First
Product Reviews
K
Verified Purchase
Kim
Battle Creek, US
★★★★★ 3
Cute and good !
Size: 1.8in for Puppy Dogs
My dogs like them! There kinda hard to clean but I just soak them in hot water and give them a good scrub! Can also use them for a fetch ball
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on November 10, 2025
C
Verified Purchase
CheezyRiderAZ
Natrona Heights, US
★★★★★ 5
DURABLE
Size: 2.8in for Small & Medium Dogs
My dog loves these balls almost as much as she loves tennis balls, which she tears up within a day. These two balls have lasted over a week with no signs of wear. I was unsure when I ordered them but they do bounce, not quite like a tennis ball but enough to keep my dog's attention. When using toothpaste in these balls I had to put it deep into the openings or she just licks it off of the surface and when its that deep, it doesn't squeeze out like I think it should. It just stays in the crevasses and gets old and hard. As a ball it's great, as a toothpaste delivery system it's not so great.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on October 30, 2023
B
Verified Purchase
BarbieJ
Grantham, US
★★★★★ 5
Perfect For Sophia!
Size: 1.8in for Puppy Dogs, Size: 1.8in for Puppy Dogs
These little balls are the perfect size for Sophia who is a 7 lb Yorkie with a teeny tiny mouth. The slots in the balls make them very easy for her little teeth to grab hold of and carry. The quality of the rubber is excellent, strong and durable. They're holding up great so far! She loves them and so does her Mama! 5 stars!
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on April 23, 2024
M
Verified Purchase
Mommakins
San Leandro, US
★★★★★ 1
Horrible, don't buy
Size: 1.8in for Puppy Dogs
I wanted to love these. They had so much potential. It's a good size. It seems like a good shape. But ... 1) first red flag should have been the packaging. It looked like it was a dollar store item that had beenblost on the shelves for years. 2) the rubber is super flexible. I was expecting it to be sturdier. I can flatten the ball without lich force. Maybe that doesn't matter. Naybe flexible is good. But I never got a chance to test out it's durability against a pup because... 3) it smelled. I expected it to smell like rubber, like most rubber toys. Rubber smell is okay. Usually rubber smell goes away. But, this was NOT a rubber smell. It smells like peppermint or something similar. It's like someone sprayed essential oils when mixing the rubber and now the smell will not leave. I soaked it in dawn soap half the day and overnight. I rubbed. I scrubbed. The smell actually gets worst the more you scrub it!!! It's like a scented marker or scented eraser, but you do NOT want the scent in a dog toy! My dog cannot smell the food in it because the smell of the weird mint-like scent is so overpowering. He saw it had food, and wanted it, but every time he started sniffing wildly, he would recoil. Whoever thought it was a good idea to scent this was WRONG. Mint in the form of an essential oil is extremely poisonous to dogs!! So, why they would put a mint-loke scent ijto the dog's rubber treat toy is beyond me. I would return this if I hadn't throw out the package immediately. I considered pulling the package out of the trash once i realized the scent issue but other trash had already been dumped into the trash can over it and i didn't want to dig through trash. The ball is still soaking in soap. I scrubbed again this morning. I let obe dry out. No luck. It actually seems to get worst the more you scrub, like it really is embedded in the rubber itself. Yuck!!!
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on January 1, 2022
L
Verified Purchase
LoriBeth
Alexandria, US
★★★★★ 5
Great enrichment
Size: 2.8in for Small & Medium Dogs
These are great for our 3 dogs, they’re durable and strong. The pup ford training treats fit great into these and it takes our dogs a good bit to get all the treats out. Easy to clean and a great enrichment toy, will buy again!
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on February 6, 2026

recommand products