Small and fine: electronics pliers for fine installation work

Short, smooth and good: 115 mm long for plenty of freedom of movement even where space is restricted

Space is usually tight when working on electronic equipment, printed circuit boards and precision constructions such as measuring equipment or delicate apparatus. A compact tool which can also be used to work well even in poorly accessible areas is therefore helpful.

With a length of just 115 mm and their slim, flat head, these 35 31 115 electronics pliers from Knipex are the ideal tool for the delicate gripping, holding and bending of sensitive components.

The gripping surfaces, which are rounded at the front, are smooth ground to protect sensitive surfaces.

With box joint design and double spring – smooth operating and accurate

The smaller and more sensitive the component being worked on, the greater the challenges placed on pliers. The accurate, well-measured transmission of manual force to the component is vital. The mechanics of the Knipex 35 31 115 are very finely adjusted. The box joint is solid and smooth operating, because the inner handle is guided on both sides by the outer handle. This ensures precise running without any tilting effect. The low friction double spring supports the gentle opening of the pliers.

High Knipex quality standards and safety rust protection

The handles of the Knipex 35 31 115 electronics pliers are forged from special tool steel, oil-hardened, carefully deburred, mirror-polished and completed with opening spring and rivet to produce gripping pliers. Quality and safety are paramount – also regarding rust protection. There is no chrome-plating on the Knipex 35 31 115, so that no pieces of chrome can peel off and fall onto printed circuit boards. The mirror polish in conjunction with a fine oil film provides perfectly adequate corrosion protection for the pliers during workshop use. The pliers are always protected if the oil film is replaced occasionally.