Strange Pro Series Dual Rear Brake Kit For Strange 3.150″ Small GM Housing Ends 1 Pc Rotors, 4 Piston Calipers & DTC-30 Brake Pads

Designed Specifically For Drag Racing

For Strange 3.150″ Small GM Housing Ends – H1143

Orientation Differs From Picture
Calipers are repositioned to provide shock clearance

Requires
• Strange housing ends
• Ball style axle bearings
• Caliper mount relief isn’t correct for tapered bearings
• 2.832″ brake offset

Compatibility Issues
Moser #7900 Housing Ends
Brake kit will not fit these ends

Moser #7900FM Housing Ends
Will fit these ends using spacers – Sold Separately
• For ball bearing – B1105GB
• For tapered bearing – B1105G

One Piece Forged Steel Rotors – B2792 / B2793
• Directional slots increase air flow and reduce weight
• One piece design eliminates bolts & safety wire
• Hat section drilled & milled to further reduce weight
• 4 1/2″, 4 3/4″ & 5″ Uni-Lug bolt circles for both 1/2″ & 5/8″ studs

Four Piston Directional Calipers – B5002 / B5004
• Aluminum bodies drastically reduce weight
• 1.625″ & 1.750″ pistons vary pressure decreasing pad taper
• Stainless steel pistons resist corrosion
• Anti-rattle clips reduce brake pad vibration and noise

DTC-30 Semi Metallic Brake Pads – B5010
• Provides the best starting-line cold holding power
• Recommended for vehicles going 150 MPH or less in the 1/4 mile

Aluminum Caliper Mounts
• Billet one piece design
• Eliminates bolts, spacers & nuts that require periodic maintenance

Housing End Stud Kit – H1133STKIT
• Provides additional components not supplied in most aftermarket kits

Need More Wheel Clearance?
Evolution 4 Low Profile Caliper Option – OPRB11

Want Billet Calipers?
Evolution 4 Billet Caliper Option – OPRB08

Use Teflon® tape or liquid on the pipe threads of the fitting
Leave a few threads from the tip uncoated
This will avoid depositing material inside the caliper
Torque fitting to 25 ft lbs