J1939 To NMEA2000® Adaptor

J1939 To NMEA2000® AdaptorThe 3185 J1939 Adaptor is an important part of our NMEA2000 based Vessel Monitoring and Control System. The Oceanic Systems 3185 J1939 to NMEA2000 Adaptor takes standard J1939 engine and transmission messages and transmits them onto the NMEA2000 network. The J1939 is certified to work with NMEA2000 and the interface is optically isolated to prevent ground loop problems and is read only so no messages are sent to the J1939 interface for absolute

The 3185 J1939 Adaptor is an important part of our NMEA2000® based Vessel Monitoring and Control System.

The Oceanic Systems 3185 J1939 to NMEA2000® Adaptor takes standard J1939 engine and transmission messages and transmits them onto the NMEA2000® network.
The J1939 is certified to work with NMEA2000® and the interface is optically isolated to prevent ground loop problems and is read-only so no messages are sent to the J1939 interface for absolute safety. It is equipped with LEDs to indicate when J1939 messages are received and when NMEA2000®messages are transmitted. It requires no user setup menus but the simple set of two small rotary source and address switches so multiple Adaptors can exist on the same networks.

The J1939 connections to the unit are made via boat builder preferred WAGO Cage Clamp terminal blocks which allow either solid or multistranded wires from 0.08 to 1.5mm² to be connected quickly and securely. The 3185 can be either panel mounted or din rail mounted using the DIN rail mounting clips provided.

Includes:

• User Manual
• DIN rail mounting clips provided
• WAGO terminals for J1939 connection
• J1939 interface optically isolated
• J1939 interface is Read Only
• Switch selectable J1939 Source
• J1939 Valid Message LED
• Switch settable NMEA Device Instance
• Panel or DIN rail mounting
• Low Cost
• Certified to NMEA2000®