NITTO F-019AA Front Supporter

NITTO F-019AA Front SupporterFront bag supporter with adjustable arm angle This item allows you to simply and intuitively attach the front bag to the handlebar, and since the bag does not sway significantly when riding, you can take out the camera and energy bar as you wish. By inserting the bag into the support arm and attaching the included washer and button bolt to the end, the bag is also prevented from falling out when riding or when subjected to vibrations from bumps. This

Front bag supporter with adjustable arm angle

This item allows you to simply and intuitively attach the front bag to the handlebar, and since the bag does not sway significantly when riding, you can take out the camera and energy bar as you wish.

By inserting the bag into the support arm and attaching the included washer and button bolt to the end, the bag is also prevented from falling out when riding or when subjected to vibrations from bumps. This button bolt should be installed with 4-6 N.m.

[Install Tips].

The handlebar body can accommodate an outer diameter of Φ31.8mm. If you use shims or other means to attach it to a diameter smaller than that, the fixing bolt may loosen or be damaged due to misalignment during use.

The load capacity of the front bag supporter is 5.0 kg when supported with a front carrier or bag supporter, and 1.0 kg when not supported.

When installing on the handlebar, tighten the bolts with 4-6N.m so that the clearance between the clamp adapter body and the lid is even front to back.