Pay in installments of $6.49 with
,
and
Shipping Estimate
USA
- USA
- CAN
- USA
- CAN
Ships within 48 hours · Estimated delivery Sep 3 - Sep 8
Promo Codes Available:
For Your Every Summer RSVP, with Code: SUMMER15
Description
Matek XCLASS PDB 8-60v FCHUB-12S V2Are you wanting to buy the Matek XCLASS PDB 8 60v FCHUB 12S V2 in Australia? The Matek XCLASS PDB 8 60v FCHUB 12S was designed to connect all your drone electronics together with maximum efficiency. This PDB distributes power from a 2~6S LiPo pack to 4 ESCs, as well as providing regulated & filtered BEC 5V 6A outputs for powering Cameras, RC receiver, Flight Controllers, LEDs, etc. This board is one of the leaders of the market where durability is
Are you wanting to buy the Matek XCLASS PDB 8-60v FCHUB-12S V2 in Australia?
The Matek XCLASS PDB 8-60v FCHUB-12S was designed to connect all your drone electronics together with maximum efficiency.
This PDB distributes power from a 2~6S LiPo pack to 4 ESCs, as well as providing regulated & filtered BEC 5V/6A outputs for powering Cameras, RC receiver, Flight Controllers, LEDs, etc.
This board is one of the leaders of the market where durability is concerned.
Quick Start Guide (PDF)
PDB
- Input voltage range: 8~60V (3~12S LiPo)
- 4x70A cont, 4x110A burst
- 4x ESC power /signal/ telemetry pads
- Current Senor: 440A, 3.3V ADC, Scale 75
- 2x LED indicators for 5V, 12V
- 1K:20K voltage divider built-in
JST-SH 8pin connector
- “V” pad: 12V or VBat voltage selectable
- G: GND
- Curr: current sensor signal
- TLM: for BlHeli32 ESC telemetry
- S1~S4: ESC signal
BEC 5V output (5V pad)
- Voltage: 5.1 +/- 0.1VDC
- Continuous current 5 Amps, Max.6A
- Short-circuit tolerant (2 seconds)
- Overcurrent protection & self-recovery
BEC 12V output (12V pad)
- Voltage: 12.0 +/- 0.2VDC (Input voltage >=12V)
- Continuous current 4 Amps, Max.5A
- Input voltage<12V, Output voltage = Input voltage
- Short-circuit tolerant (2 seconds)
- Overcurrent protection & self-recovery
Switchable 12V output (12VSW pad)
- 12V ON/OFF switchable via PINIO(high/low level)
- support constant 2A
- can be use for powering VTX,LED etc.
BEC 3.3V output
- Linear Regulator
- Continuous current: 500mA
Physical
- Mounting: 30.5 x 30.5mm, Φ3mm
- Dimensions: 55 x 50 x 6 mm
- Weight: 21g
Including
- 1x FCHUB-12S V2
- 1x SH1.0_8pin cable 5cm, 2x SH1.0_8pin connectors
BROWSE MORE
Browse all MATEK
Browse all FC's
Browse all DRONE ELECTRONICS
Shipping Notes
- Free Standard Shipping on $100+ Orders to the USA.
- Except Preorder products are shipped in 48 hours.
- Delivery to the USA:
- Standard Shipping : 3-10 business days
- If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
- We offer a 30-day return/exchange service after receiving.
- Final sale items are not eligible for returns or exchanges.
- To process your return/exchange, please contact us at [email protected]
- Please click here for more details>>> Return & Exchange Policy
4.5 ★★★★★
Based on 11 reviews
Sort
Product Reviews
★★★★★ 5
Great product, thoughtful design, great customer service
Color: Black, Size: 40 oz
I don't write a lot of reviews, but I felt like this product deserved one. This is an excellent cold brew maker. It is very easy to use and has a great 1,200 mL capacity. The plastic construction is more versatile (less fragile) than other brewers made from glass. The filtration system eliminates the sludge that other brew systems leave. The packaging is very thoughtful - a scoop and sponge are included. The scoop is easily overlooked, but it is the perfect size to clean the used grounds out of the filter. The sponge is an unexpectedly useful form factor to help with cleaning. Hopefully the sponges can be ordered separately, since sponges don't last forever.
Some minor downsides:
Cleaning is moderately easy, but the only component that is recommended for the dishwasher is the pitcher (which is also easiest to clean by hand). All of the other elements are recommended for hand washing, which doesn't take long.
The way the filter is configured, the pitcher will work most effectively if stored (at least for part of the brew cycle) on its side. However, there is a vent in the lid that is prone to leaking when the pitcher is stored on its side. Brewing upright can lead to the top grounds not getting exposed to water.
Unfortunately, one of the pieces broke during routine use after a couple of months: the pitcher lid is attached with a couple of hinges that snap the lid into place on the pitcher. One of the hinge attachments broke. I contacted customer service and a replacement pitcher arrived four days later. I'd recommend being careful with these hinge attachments as they seem prone to break. At the same time, the customer service is very responsive and suggests that they take support of their products seriously.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 1, 2025
★★★★★ 5
Nice little cold brew pitcher
Color: Black, Size: 40 oz
Easy to use and very easy to clean. We have made one batch of cold brew so far and are very pleased with the results, the suggested measurements produced a very smooth tasting coffee. Definitely worth trying for the price.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 19, 2026
★★★★★ 5
Best cold brew ever
Color: Black, Size: 40 oz
How did I live without this?? My ice coffee made in this is the best I have ever had. It is very easy to use and also very easy to clean. I was very impressed with the quality of the pitcher. It is very thick acrylic and cleans up great with absolutely no staining or discoloration. I am going to be ordering another for my brother! I highly recommend this one!
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on April 19, 2026
★★★★★ 4
Very nice but -
Color: Black, Size: 64 oz
Got it today. Just put it to use and made some cold brew. Looks nice and sturdy and doesn’t leak. Has a great large capacity to make a lot of cold brew. Lid closure is great and seals nicely. Very easy to use and user friendly. The plastic material is very thick feeling so that tells me it will withstand quite a bit. I like it so far.
My only issue is as soon as I opened the box and pulled the spoon out, it was broken. The bottom stand is completely broken and barely stands up. So that’s disappointing. Otherwise, seems very nice.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on March 9, 2026
★★★★★ 5
Reliable and Easy to Use Cold Brew Coffee Maker
Color: Black, Size: 40 oz, Color: Black, Size: 40 oz
This cold brew maker is easy to use and does the job well. I get smooth coffee every time without bitterness. The size is good and fits in my fridge without taking much space. The filter works well and keeps most of the grounds out of the coffee.
Cleaning is simple and does not take much time. The build feels solid for daily use. I like that I can control how strong the coffee is by changing the water and coffee ratio.
One thing to know is that you need coarse ground coffee for best results. (I use Bizzy coffee) Letting it steep longer makes the flavor better. It is not insulated, so you should keep it in the fridge while brewing.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on February 7, 2026
recommand products
Learning Resources Express Your Feelings Playing Cards, 100-Card SEL Flash Card Set for Kids, Social Emotional Learning Activities for Home, Classrooms & Counsellors, Ages 3+
50.00
VIGA Magnetic Dress Up Boy Toy Educational Wooden Magnetic Outfit Set with 40+ Pieces 8 Themed Looks Develops Imagination, Hand-Eye Coordination, and Social Skills Suitable for Ages 3 and Up
69.00
The Sims 2: Pets - Gamecube
14.99
Viga Farm, 5 Piece Block Puzzle, Montessori Wooden Toy, Develops Sensory, Cognitive & Fine Motor Skills, Non-Toxic & Eco-friendly Kids Educational Toy, Suitable for Boys and Girls Aged 18M+
49.00
Viga Farm, 24 Piece Jigsaw Puzzle, Montessori Wooden Toy, Develops Sensory, Cognitive & Fine Motor Skills, Non-Toxic & Eco-friendly Kids Educational Toy, Suitable for Boys and Girls Aged 2Y+
35.00