HeatnBond FeatherLite Iron-On Adhesive

HeatnBond FeatherLite Iron-On AdhesiveHeatnBond FeatherLite is a paper backed, iron on, sewable, double sided adhesive for bonding fabric without extra weight or stiffness. This lightweight formula is great for multi layer pieces, landscape quilts, and wearables since it gets even softer after laundering. Use it in place of pinning or basting for appliqu shapes on quilts, wall hangings and attire. Draw directly on the paper backing to easily design appliqu pieces! Product Details 17

HeatnBond FeatherLite is a paper backed, iron-on, sewable, double-sided adhesive for bonding fabric without extra weight or stiffness. This lightweight formula is great for multi-layer pieces, landscape quilts, and wearables since it gets even softer after laundering. Use it in place of pinning or basting for appliqué shapes on quilts, wall hangings and attire. Draw directly on the paper backing to easily design appliqué pieces!

Product Details

• 17 inches x 35 yards bolt
• Permanent double-sided iron-on adhesive
• Solid sheet adhesive on a paper backing
• Doesn’t gum up needles
• Saves time by eliminating pinning
• Proudly made in the USA

Video

General Directions

Pre-wash all materials (without fabric softener) you will be using prior to fusing. Pre-test adhesive on materials prior to fusing.

1. Preheat iron to medium heat, No steam. Place adhesive on back of material to be bonded (paper liner should face up).
2. Using firm pressure in a circular motion, iron the paper for 2 seconds. Repeat until entire surface is bonded. Allow to cool.
3. Cut to size or shape needed. Peel off paper liner.
4. Place material, adhesive side down, on top of project. Using firm pressure in a circular motion, iron for 4-6 seconds on each section until entire piece is bonded.
5. Times listed above are for cotton. Iron thick fabrics an additional 2 seconds from the back of the project.
6. Hand or machine sew along edges.

Tips

• If stitching is NOT desired, use HeatnBond Ultrahold in the red package.
• Do not touch iron directly to the adhesive sheet. Do not iron directly to your ironing board.
• HeatnBond FeatherLite can be run thru an INKJET printer (NOT a laser jet or copy machine). Cut to printer size, feed into printer to print on the paper side, set printer to Draft or Transparency setting, allow to dry before touching. Run any lettering in mirror setting so they are the correct orientation when cut from the fabric.
• Must be sewn or otherwise attached before washing. Machine wash cold and dry on low heat or no heat (and in accordance to garment / fabric washing directions). Avoid repeated or excessive ironing to the area after fusing.