Aico EI128R Mains Hard Wired Relay Module with 5A Relay 230V

Aico EI128R Mains Hard Wired Relay Module with 5A Relay 230VAico Mains Hard Wired Relay Module with 5A Relay 230V This Relay Module triggers external devices if the alarms on the system are activated, such as a strobe light or telecare device. Features Mains powered Connects with the alarm system through a hard wire interconnect Easy to install with additional trunking knock outs easi fit base footprint Allows for simple testing of domestic and external systems Compatible with the 3000, Ei2110e Multi Sensor

Aico Mains Hard Wired Relay Module with 5A Relay 230V

This Relay Module triggers external devices if the alarms on the system are activated, such as a strobe light or telecare device.

Features

• Mains powered
• Connects with the alarm system through a hard wire interconnect
• Easy to install with additional trunking knock outs easi-fit base footprint
• Allows for simple testing of domestic and external systems
• Compatible with the 3000, Ei2110e Multi-Sensor Fire Alarm, 160e Series alarms and the 140RC Series

Specifications

• The Relay is designed to operate whilst the alarm system is sounding, to signal ancillary devices such as door closers, extractors, remote sounders etc. When any of the interconnected alarms sound the signal will cause the relay contacts to switch.
• The Relay is mains powered and operates on receipt of a signal from the interconnect line of a smoke, heat or CO alarm. The relay does not operate if mains power is not present.
• Volt free contacts – (Normally Open or Normally Closed) rated up to 240V AC/5 Amps, making it suitable for use with a wide range of AC or DC voltages.
• The Ei128R is designed for siting under one of the smoke/heat alarms listed above. However, a cover is supplied if installing remotely or with 260 series CO alarms.
• More than one Relay can be used in a set of interconnected alarms on the condition that no more than 12 units are used in the system (1 x Ei128R counts as one unit).
• Fitted with a 4 way connector block for ease of wiring.
• The relay can be set for Continuous or Pulse operation by operation of a manual switch – when in Pulse operation mode, the relay contacts will automatically switch back to their original state after 5 seconds.
• Features 3 x 25mm trunking knockouts for surface wiring and centre knockout for recess wiring.
• Manufactured in Ireland.

Data Sheet:

Instruction: