Genesis Offroad Dual Battery Kit, Gen 3, 2007 - 2021 Toyota Tundra
SKU: 61006473575

Genesis Offroad Dual Battery Kit, Gen 3, 2007 - 2021 Toyota Tundra

Sale price$359.55 Regular price$399.50
Save 10%

Shipping Estimate
USA
  • USA
  • CAN

Ships within 48 hours · Estimated delivery Jul 8 - Jul 13

Promo Codes Available:

For Your Every Summer RSVP, with Code: SUMMER15

Description

Genesis Offroad Dual Battery Kit, Gen 3, 2007 - 2021 Toyota TundraGen 3 Dual Battery System for 2007 2021 Toyota Tundra Genesis Offroad launched the first completely integrated, easy to install dual battery system for the Jeep Wrangler in 2013. Never satisfied with 'good enough', we have listened to customer feedback and refined our dual battery system to be even better suited to meet the demands of today's off road vehicles and their drivers. Our purpose remains the same to allow you to enjoy your aftermarket

Gen 3 Dual Battery System

for 2007 - 2021 Toyota Tundra

Genesis Offroad launched the first completely integrated, easy to install dual battery system for the Jeep Wrangler in 2013. Never satisfied with 'good enough', we have listened to customer feedback and refined our dual battery system to be even better suited to meet the demands of today's off road vehicles and their drivers.

Our purpose remains the same - to allow you to enjoy your aftermarket electrical accessories without worrying about draining down your cranking battery. Even if your cranking battery gets too low to start the engine, simply press a button to jump start from your second battery. Gone are the old days of reading wire schematics to figure out how to add a second battery to your vehicle with a manual selector switch or isolator device. Genesis dual battery kits are completely pre-wired for you out of the box for easy installation. No wire strippers or crimpers required!

What's new with Gen 3

1 - New heavy duty battery combiner
Allows your engine's alternator to charge your cranking and accessory batteries.
Connects batteries together in parallel while driving, then separates them once the voltage drops below 12.7v to protect your cranking battery from getting drained by your accessories.
Rated for 300 amps continuous current flow, and spikes of up 2500 amps for 10 seconds to handle anything you can throw at it.
Compatible with all modern high output alternators.
Uses NO power to keep batteries connected, allows batteries to stay fully charged when not in use and run accessories even longer.
Generates NO heat, since no current is flowing through it while the batteries are connected, the battery combiner produces no heat at all.
More robust and more reliable design means more worry-free adventures

2 - New boost button
Now includes 3 user-selectable modes - Auto, On, and Off
'Auto' mode automatically connects batteries when either one is above 13.1v for 90 seconds, and disconnects them when they drop below 12.7v for 30 seconds.
'On' mode will manually connect the batteries together. Use this to jump start the engine when the cranking battery is low, or manually provide extra run time to your accessories by using both batteries together.
'Off' mode will manually separate the batteries. Use this when you want to leave the batteries isolated for any reason. Note the alternator will not charge the Aux battery while in this mode.
The green halo light will turn on to indicate the batteries are connected, and the light will be off when the batteries are separated.

3 - New bus bars
Now includes 3 tall studs and 3 small screws for power & ground wire connections
Different stud sizes 1/4", 5/16", and 3/8" give you more flexibility for connecting your heavy duty accessory cables such as a winch, stereo amplifier, air compressor, fuse panels, etc.
Lighter gauge wires such as LED lights, CB, etc, can use the 3 small screws for connecting #10 sized ring terminals.
Any accessories connected to the bus bars will run from the Aux battery and will not drain down the cranking battery.
The protective cover flips up for easy access for routing your wires.


4 - New Heavy Duty Cables
Higher solid copper strand count for more current carrying capacity and more flexibility
Thicker insulating jacket for even more protection from the elements
Heavy duty adhesive lined heat shrink protects the wire from corrosion
Tin-plated copper lugs and post clamps for superior conductivity






New Cover
Our most requested feature!
Completely covers all the electronics and wiring for protection and a cleaner look
Easy flip up access to your bus bars













G Screen Monitoring System port
Integrated connection point for plugging in the optional G Screen.
This kit uses G Screen v5.3, part number 227-GS





System Includes:
  • Gen 3 Power Hub
    • Smart battery combiner
    • Boost switch
    • Accessory Bus bars
    • G Screen port
    • All wiring
  • Steel Battery Tray
  • Installation hardware
Batteries: Sold separately. Matching Group 25 batteries are required.




Battery Options:
  • Requires 2 Group 25 size batteries, any brand. 
  • Batteries must be the same physical size for the lid to securely hold them in place
  • We recommend the Full Throttle FT750-25 or the Odyssey ODP-AGM25, or any other high quality AGM batteries
  • The Optima Red Top Group 25 and the Optima Yellow Top Group 75/25 will work, but due to their physically smaller size, they have far less capacity than other brands, and therefore we do not recommend Optima batteries with this kit.
  • Traditional wet lead acid batteries are NOT recommended
  • Note the stock battery is NOT compatible with this kit


Optional Ring Terminal

Are you planning on connecting some accessories to the power & ground bus bars? We offer this convenient 16 piece assortment of high quality, adhesive-lined heat shrink ring terminals. These are much better quality than the cheap ring terminals at the auto parts stores.

Each package Includes 4 each of the following sizes to match the bus bars on the Gen 3 Power Hub.

Each package Includes 4 each of the following sizes to match the bus bars on the Gen 3 Power Hub.

  • #10 ring, 16-14ga
  • 1/4" ring, 16-14ga
  • 5/16" ring, 12-10ga
  • 3/8" ring, 12-10ga

 

Shipping Notes
  • Free Standard Shipping on $100+ Orders to the USA.
  • Except Preorder products are shipped in 48 hours.
  • Delivery to the USA:
  1. Standard Shipping : 3-10 business days
  • If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
  • We offer a 30-day return/exchange service after receiving.
  • Final sale items are not eligible for returns or exchanges.
  • To process your return/exchange, please contact us at [email protected]
  • Please click here for more details>>> Return & Exchange Policy
SKU: 61006473575

Discover Niche Categories That Outsell

Top-Converting Item to Boost Your Average Order

4.5 ★★★★★
Based on 1645 reviews
Sort
Highest Rating
Newest First
Oldest First
Product Reviews
T
TLau
Lowell, US
★★★★★ 4
Good fit for Acura MDX
Size: 8.8" x 9.3" x 1.1"
This is an air cabin filter that will fit many cars, and in my case a 2019 MDX. Since this kind of filter is not doing anything critical like keeping dirt out of an engine, I shop around for non-OEM filters for something that strikes a balance between price versus performance. This filter just filters out dust in a car cabin, and when we’re not in our cars, we don’t have the benefit of an air filter when we are walking around outdoors. At a fraction of the price of an Acura filter, this filter seems to strike that balance. The filter media looks sturdy and is embedded with charcoal to help absorb odors. Installation is very straightforward in my MDX, and similar in most cars. There is a compartment door inside the glovebox that first must be removed before changing the filter. Pay attention to the direction flow arrow that shows which way the filter should be installed. Overall I am satisfied with this filter. It is inexpensive, fits perfectly, and seems to do the job just fine. It is definitely worth trying if you are trying to save money.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on October 12, 2024
S
Shop by Interest
Battle Creek, US
★★★★★ 5
These filters do the job
Size: 2Pcs
Fits great in my '08 Accord LX and my '19 Accord Sport 2.0t. They filter air well and are easy to install like any cabin air filter in a Honda. I am pleased. Good value for the price.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on October 8, 2025
L
Lars A. Morgan
Cuba, US
★★★★★ 5
Fit my 2014 Odyssey TE
Size: 8.8" x 9.3" x 1.1"
Comes with printed instructions for those who haven't changed it before. Here is the specific use case from my van. On my 2014 TE its easy to access behind the glove box, open to usual full open then just push the left and right sides in to allow the glove box to come fully out. It may pop off of the mounts, don't panic it snaps right back on. Then look for the little rectangular panel with two small levers on either side. on the black plastic under the dash that you can now see and access. Press the levers and pull towards you, doing a bit of a wiggle to get it out. Its tight, but it will come out with having to break it. Don't gorilla hands it, it will break. There is a directional arrow on the filter, which you have to remove from the wrapper before installing. Yes, someone *will* forget that. Reassembly the reverse of removal. Check that video sharing site online if you need visual instructions.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on September 27, 2024
M
Verified Purchase
Marcone B. Costa
San Leandro, US
★★★★★ 5
Easy to install and works flawlessly.
It has done what it is supposed to do flawlessly in the past few months. It looks and fits perfectly.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on March 3, 2026
S
Verified Purchase
Shawn Riddick
Phoenix, US
★★★★★ 5
Same as original
Starter was exactly the same fittings as original for 2000 Toyota Camry and started the car no problem.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on February 7, 2026

recommand products