JL Audio AP600/6 Amplifier 600 Watt 6 Channel

JL Audio AP600/6 Amplifier 600 Watt 6 ChannelJL Audio AP600 6 Amplifier 600 Watt 6 Channel Model: 010 03430 00 600 WATT 6 CHANNEL AMPLIFIER: This staggered power 6 channel amplifier can power up to a maximum of six pairs of speakers or four pairs of speakers and one subwoofer. EASY TUNE FEATURE: For additional optimization, pair with a Fusion stereo with built in DSP, and download the Fusion Audio app for selectable profiles. This enables the Easy Tune feature, which streamlines amplifier setup

JL Audio AP600/6 Amplifier 600 Watt 6 Channel

• 600-WATT 6 CHANNEL AMPLIFIER: This staggered-power 6 channel amplifier can power up to a maximum of six pairs of speakers or four pairs of speakers and one subwoofer.


• EASY TUNE FEATURE: For additional optimization, pair with a Fusion® stereo with built-in DSP, and download the Fusion® Audio app for selectable profiles. This enables the Easy Tune feature, which streamlines amplifier setup to ensure superior sound quality and system protection.


• CLASS-D AMPLIFIER TECHNOLOGY: The highly efficient Class-D design provides lower battery drain with a higher output than Class-AB amplifiers. This delivers increased power to the connected speakers/subwoofers for an enhanced level of audio performance.


• RUGGED DESIGN: These amplifiers offer superior levels of durability and are built to IP67 standards (excluding cables) to withstand abuse in harsh marine environments.

Channels
6

Physical dimensions (Height)
1.86" (47 mm)

Physical dimensions (Width)
11.81" (300 mm)

Physical dimensions (Depth)
5.90" (150 mm)

Operating voltage
9-16 VDC

Water and dust rating
IP67

Operating temperature range
4° to 149° F (-20° to 65° C)

Warranty
3 years

Audio

Amplifier class
Class D

Rated continuous (RMS) power (14.4 V input @ 4 Ohm less than 1% THD)
Channels 1-4: 50 W x 4/150 W x 2 (Bridged); Channels 5-6: 100 W x 2/300 x 1 (Bridged)

Rated continuous (RMS) power (14.4 V input @ 2 Ohm less than 1% THD)
Channels 1-4: 75 W x 4; Channels 5-6: 150 W x 2

Signal-to-Noise Ratio, referred to 1 W (A-weighted, 20 Hz - 20 kHz noise bandwidth): Analog Inputs
Greater than 70 dB

Frequency response (+0, -1dB)
20 Hz-20 kHz

Input sensitivity @ RCA inputs
Switchable from 200 mV-2 V RMS (Low) to 800 mV-8 V RMS (High)

Current consumption (Standby)
Less than 1mA

Current consumption (Idle)
1000mA-1500mA

Fuse rating
70A

Recommended fuse type(s)
AFS, AGU or MaxiFuse

Min. copper power/Ground wire gauge
4 AWG wire

Protection circuits
Input under/over voltage Over temperature Output short circuit

What's in the Box:

• JL Audio AP amplifier


• Four mounting screws


• Documentation