Robert Axle Project 159, 162 or 165mm M12x1.5 Trainer Axle (TRA212)

Robert Axle Project 159, 162 or 165mm M12x1.5 Trainer Axle (TRA212)DESCRIPTION This Trainer Axle is designed to adapt your high quality bike to your wheel on trainer. These are compatible with all the popular brands: Blackburn, Bkool, Cyclops, Elite, Kinetic, Tacx, Wahoo and more. Our first priority is building a precision thru axle. Our axles fit into your bike as well or better than the stock thru axle. The axle is installed with a simple 5 mm hex allen key. The same tool that you carry on every ride. The best

DESCRIPTION

• This Trainer Axle is designed to adapt your high quality bike to your wheel-on trainer. These are compatible with all the popular brands: Blackburn, Bkool, Cyclops, Elite, Kinetic, Tacx, Wahoo and more.
• Our first priority is building a precision thru-axle. Our axles fit into your bike as well or better than the stock thru axle.
• The axle is installed with a simple 5 mm hex/allen key. The same tool that you carry on every ride.
• The best part? When it’s time for your race or time to head outside, simply remove your bike from the trainer, remove the drive side axle end and go. Our axle is suitable for use on or off the trainer. Indoors or out.
• Important: Before you order, make sure your specific trainer will accommodate the width of your modern thru-axle equipped bike. Measure your trainer at the widest setting and measure the outside width of your bike frame. Our the trainer axle ends will extend 15 mm past your frame on each side. Our axles are not designed for direct-drive trainers.

SPECIFICATION

Robert Axle for Trainers replaces your stock 12 mm thru axle so you can use your bike on a trainer.

• This axle is compatible with 1up, Blackburn, Cyclops, Kinetic, Tacx, Wahoo and many other on-wheel resistance trainers.
• The true length of the axle shaft is 165 mm, but can be shortened to 162 mm or 159 mm using the included 3 mm or 6 mm spacer.  Please note: Thru-axle lengths do not equal hub standards. An axle has to be longer than the hub to fit in the frame. A 12×142 hub does not equal a 142 mm long axle.
• This axle has a 1.5 mm thread pitch.
• The axle shaft and axle ends are precision CNC machined from 7075 aluminum, and hard anodized for rugged durability.
• No special tools required. Design allows for installation or wheel removal using your standard 5 mm hex wrench.

COMPATIBLE WITH

Giant - Contend, Defy, Propel, TCR