1/2"W x 1/8"T 50FT (2 Rolls x 25FT) Adhesive Foam Tape, Thermal Rubber Strip

1/2"W x 1/8"T 50FT (2 Rolls x 25FT) Adhesive Foam Tape, Thermal Rubber Strip1 2"W x 1 8"T Adhesive Foam Tape Key Features Material: High density, closed cell foam rubber Dimensions: 1 2 in (12. 7mm) Width x 1 8 in (3. 2mm) Thickness Total Length: 50 ft (15. 2m), supplied as 3 rolls Adhesive: High tack, single sided pressure sensitive adhesive backing Operating Temperature Range: 58F to 302F ( 50C to 150C) Functions: Seals against drafts, dust, noise, moisture, and light Resistance: Weather, UV, and ozone resistant Replaces

1/2"W x 1/8"T Adhesive Foam Tape

Key Features

• Material: High-density, closed-cell foam rubber
• Dimensions: 1/2 in (12.7mm) Width x 1/8 in (3.2mm) Thickness
• Total Length: 50 ft (15.2m), supplied as 3 rolls
• Adhesive: High-tack, single-sided pressure-sensitive adhesive backing
• Operating Temperature Range: -58°F to 302°F (-50°C to 150°C)
• Functions: Seals against drafts, dust, noise, moisture, and light
• Resistance: Weather, UV, and ozone resistant

Replaces / Cross-Reference Part Numbers

• Universal-fit sealing tape for general purpose weather stripping applications. Suitable for replacing deteriorated original foam gaskets and seals on a wide range of equipment.

Compatibility & Fitment

• Designed to seal gaps from approximately 1/16 in to 1/8 in.
• Applications: Interior and exterior door frames, window sashes, automotive doors and trunks, marine hatches, HVAC units, and electronic enclosures.
• Surface Compatibility: Adheres to clean, dry metal, plastic, wood, and painted surfaces.

When to Replace

• Existing seal is visibly compressed, cracked, or hardened.
• Adhesive on the old seal is failing or peeling away from the surface.
• Increased drafts, noise, or water intrusion is noticeable around sealed areas.
• Visible light is seen through gaps when the door or window is closed.

Installation Tips

• Ensure the application surface is clean, dry, and free of oil, grease, and dust. Use an appropriate cleaning solvent for preparation.
• Measure the required length and cut the tape with scissors or a utility knife.
• Peel the protective liner from the adhesive side.
• Apply the tape to the surface, pressing firmly and evenly to ensure full contact.
• Avoid stretching the material during application as this can cause it to contract over time.