GO! Flower Bunch Die (#55332)

How to Die Cut Flower Bunch Shapes:

Apply fusible web product to the wrong side of the fabric, following manufacturer’s instructions, before cutting for fusible appliqué.  

• Large Flower: Cut and fuse 4" squares. Cut 10 large flowers across the width of fabric. One yard of 40" wide fabric cuts 90 large flowers. 
• Medium Flower: Cut and fuse 3 3/4" squares. Cut 10 medium flowers across the width of fabric. One yard of 40" wide fabric cuts 90 medium flowers. 
• Small Flower: Cut and fuse 1 1/2" x 2 1/2" rectangles. Cut 16 small flowers across the width of fabric. One yard of 40" wide fabric cuts 384 small flowers. 
• Leaf/Petal: Cut and fuse 1 1/4" x 3" rectangles. Cut 28 leaves/ petals across the width of fabric. One yard of 40" wide fabric cuts 364 leaves/petals. 
• Center: Cut and fuse 1 1/4" squares. Cut 32 centers across the width of fabric. One yard of 40" wide fabric cuts 896 centers. 

Why Quilters Love the GO! Flower Bunch Die: 

• Brighten up any project with flowers created with the GO! Flower Bunch die, from quilt tops to table runners. You can even plant them in a pot with the GO! Tumbler (55445) die!  
• No templates required. The GO! Flower Bunch die includes five shapes that are typically difficult to cut by hand. 
• Mix and match the shapes to create a variety of flowers or use with other GO! floral dies to custom design your own quilted garden. 
• Quickly and easily cut four of each pre-fused applique shape in one pass thru the cutter (fusible counts as one half layer of fabric). 
• Cut flower shapes out of a variety of fabrics: cotton, batiks, wool, felt, flannel, fleece, Cuddle® fabrics and more! 
• A great way to use up scraps. 
• Free pattern downloads available to get you started. 
• Charm Pack-friendly.

AccuQuilt Benefits: 

• Cut so much more fabric in less time. 
• Get accurate cuts every time -- No slipping rulers or mistakes
• Easiest to use -- Simply place die on cutter, then fabric and cutting mat on top
• Save fabric with Two Tone Foam -- Get more out of your fabric by placing it only over the shape you want to cut. 
• Safe to use -- No blades come anywhere near your fingers

Die Tips: 

• With some fabrics, after cutting, a thread or two will remain where die blades meet. Snip threads with scissors. 
• Blades on some dies are positioned at an angle.  Align fabric to edge of shape, not edge of die board. 
• Use good quality fabric to reduce fabric stretch. 
• It's always a good idea to test cut one shape before cutting many shapes to ensure fabric orientation is correct.