Drill Guide/Template and Cleat Backers for Seadoo Retractable Cleats

Drill Guide/Template and Cleat Backers for Seadoo Retractable CleatsThis kit will make installing the Seadoo Retractable Cleat easier. It comes with a drill guide template and 2 backers for the cleats. Installation: Make sure to use the correct side of the drill template. "This Face Up" is marked on the side that should be facing up. The center hole is slightly offset. Use the drill guide template to drill 5 holes using a 1 4" (6mm) bit. In my case, I used drill portion of the 1" Milwaukee Hole Dozer. Now you can cut

This kit will make installing the Seadoo Retractable Cleat easier. It comes with a drill guide/template and 2 backers for the cleats.

Installation:

• Make sure to use the correct side of the drill template. "This Face Up" is marked on the side that should be facing up. The center hole is slightly offset.
• Use the drill guide/template to drill 5 holes using a 1/4" (6mm) bit. In my case, I used drill portion of the 1" Milwaukee Hole Dozer.
• Now you can cut the two cutouts for the cleat to drop in using a 1" (25M) hole saw. Again, I used the 1" Milwaukee Hole Dozer.
• You will need to notch the little section so the cleat will drop in. In my case, I used the side of a flat file and did about 10 good swipes.
• Now you can put the backers on from the inside of the hull and complete the remaining of the installation of the cleat.

Kit Contains:

1x Drill Guide/Template 
2x Cleat Backers

Seadoo Factory OEM Part Numbers

291006449 - Cleat Assembly
29100623 - Trim Cover
3x 234062600 - M6 Stainless Flat Washer
3x 233261200 - M6 Flange Nut