4Sevens Quark 1232 Turbo CREE Warm White LED FlashlightThe Quark Turbo features a larger, deeper reflector for improved throw! This subseries operates the same as the tactical subseries: with a significantly different UI than the regular Quarks. This UI allows the user to program both primary and secondary outputs. Please note that the specifications below are for the R5 version. The warm white version has an approximately 28% lower brightness, but the runtimes will be the same. Warm white tints are

The Quark Turbo features a larger, deeper reflector for improved throw! This subseries operates the same as the tactical subseries: with a significantly different UI than the regular Quarks. This UI allows the user to program both primary and secondary outputs.

Please note that the specifications below are for the R5 version. The warm white version has an approximately 28% lower brightness, but the runtimes will be the same. Warm white tints are closer to the tint that you would see with an incandescent light like a MagLite.

 

Overview / Main Features

 

Power: Two CR123A Batteries (3.0V~9.0V)

Output: Maximum - 230 lumens; Moonlight - 0.2 lumens

Runtime: Maximum - 1.8 hours; Moonlight - 30 days

Specifications<

 

• Powered by: 2 CR123A batteries (included)
• LED Emitter: Premium Cree XP-G R5
• Voltage range: 3.0V ~ 9.0V
• Dimensions

Length: 4.9 inches
Diameter: 1.2 inches
Weight: 2.8 ounces

• 5 Current Regulated Output Levels
• 3 Flash modes: Strobe, SOS, Beacon
• Momentary Activation
• Level Memorization
• Square threads for lifetime smooth operation
• Type III Hard Anodized finish
• Fully knurled
• Reversable/Removable Clip
• Flexible & secure hand grip accessory
• IPX-8 Waterproofing
• Impact-resistant glass lens with Dual-coating - sapphire coating on the outside and anti-reflective coating on the inside for optimal efficiency and durability.
• T-6061 Aircraft-grade Aluminum Body

Typical Output Levels and Runtimes + (LED drive current)

Moonlight: 0.2 lumens for 30 days, (1ma)
Low: 4 lumens for 5 days (10ma)
Medium: 22 lumens for 20 hours (50ma)
High: 85 lumens for 4.5 hours (250ma)
Max: 230 lumens for 1.8 hours (990ma)
Strobe: 230 lumens for 3 hours
Beacon: 0-230 lumens pulse for 23 hours

The Quark Tactical can memorize any two modes of output, from its eight total modes, to be instantly available. These two memorized modes are accessed by either tightening or loosening the head (for example, tight can be Max, and loose can be Low).

Programming Modes:
To have your Quark Tactical memorize a different mode, turn it on and loosen the head by a half-turn. Then, tighten the head at least four times rapidly (twisting it tight, then loose, then tight, etc., four times). After the fourth time, leave the head tight or loose depending which position you want to program.

After three seconds, the light will flash, signaling it is ready to be programmed. Cycle through the eight available modes by clicking the tailcap off and on. The mode sequence is as follows:

Moonlight » Low » Medium » High » Max » SOS » Strobe » Beacon

 

Once you find your desired mode, leave that mode on for ten seconds and the light will flash again, confirming that the mode has been memorized. To cancel programming before it flashes, turn the light off for three seconds.